DAFTAR PESAN ERROR LCD DAN TROUBLESHOOTING FARGO HDP 5000 (Bagian 7)

No	LCD ERROR MESSAGE	Cause	Solution
61	Lm1 Headlift Err (PC Error Message No. 217)	The Laminator failed to move or sense the lower (Lam module 1) head	Check head connections and call for service/repair
62	Lm2 Headlift Err (PC Error Message No. 218)	The Laminator failed to move or sense the upper (Lam Module 2) head.	Check head connections, call for service/repair.
63	Mag Encoder Paused (PC Error Message No. 143)	The Magnetic Encoder is in a pause state.
64	Mag Encoder Startup Error (PC Error Message No. 63 and 141)	A problem was detected during Printer start-up	Reset the Printer and try again. If this problem persists, call for technical assistance
65	Mag Verify Error (PC Error Message No. 30)	Print could not verify MAG write. OR The magnetic stripe was not encoded properly.	Check the Cards and click on Cancel Print
66	Multiple Feed (PC Error Message No. 70)	Multiple cards were fed into the Printer.	Remove all cards and try again.
67	No E-card Encoder (PC Error Message No. 202)	You are trying to send encoding data, but the Printer is not configured with this Encoder type	You are trying to send encoding data, but the Printer is not configured with this Encoder type
68	No Film (PC Error Message No. 28)	Film is not installed in the Printer. OR Film RFID tag is bad.	Install the Film and press Resume. To cancel the print, press the Cancel Print button or the Cancel button located on the Printer.
69	No Flip Module (PC Error Message No. 201)	Two-sided job sent to a onesided Printer.	Verify the Printer has flipper capabilities via the LCD Menu. If Flipper capabilities are present, ensure that the Print Both Sides option in the Driver is set correctly. Press the Resume button on the Printer’s Front Cover to continue printing. To cancel the print, press the Cancel Print button from the Driver’s display dialog.
70	No Flip Module (PC Error Message No. 45 and 201)	The desired lamination requires a Flipper Module	Change the Cartridge location of the Lamination material (if it is dual sided), or buy a Flipper Module.