DAFTAR PESAN ERROR LCD DAN TROUBLESHOOTING FARGO HDP 5000 (Bagian 3)

No	LCD ERROR MESSAGE	Cause	Solution
21	Empty Reject Bin (PC Error Message No. 265)	The reject bin is full	Remove the large number of rejected cards from the reject bin. Click OK to clear the notification message. (Note: In some cases, rejected cards are incomplete or pose a security risk, and should be disposed of properly.)
22	Failed To Initialize (PC Error Message No. 141)	A problem was detected during Printer start-up.	Reset the Printer and try again. If this problem persists, call for technical assistance.
23	Film Align Error (PC Error Message Nos. 26 and 176)	The film is not able to move correctly. Check for jams/breaks.	Check for obstruction. If the problem persists, call for technical assistance
24	Film Break/Jam (PC Error Message No. 158)	The film is not able to move correctly. Check for jams/breaks.	Check for obstruction. If the problem persists, call for technical assistance.
25	Film Low (PC Error Message No. 156)	The HDP film will soon run out.	If printing a large number of cards, replace the Film now or monitor the Printer until the Film is gone and install a new Film.
26	Film Out (PC Error Message Nos. 156 and 157)	The HDP film has run out	Install a new roll of film and press Resume to continue or Cancel to reset.
27	Film: Wrong Material (PC Error Message No. 173)	The HDP Film is not installed properly or has been damaged.	Verify the correct film is installed in the film Cartridge
28	Flipper Jam (PC Error Message Nos. 74 and 199)	A card is jammed in the card flipping area of the Printer.	Open the Printer's Flipping Module Cover. Clear any cards in the Flipping Module by opening the Printers Cover and using the Forward and/or Back buttons located on the Printer’s Front Cover. Ensure that the Flipper Module can rotate freely. Close the Printer's Flipping Module Cover. Press the Resume button on the Printer’s Front Cover to continue printing. To cancel the print, press the Cancel Print button from the Driver's display dialog.
29	Head Loading (PC Error Message No. 111)	An unrecoverable error has occurred during printing	Reset the Printer and try again. If this problem persists, call for technical assistance
30	Head Resistance (PC Error Message No. 6)	The EE setting in Driver for head resistance is out of range.	Enter a value for head resistance in the EE settings in the Driver. Reset the correct value according to the steps in the Troubleshooting Section. If this problem persists, call for technical assistance