DAFTAR PESAN ERROR LCD DAN TROUBLESHOOTING FARGO HDP 5000 (Bagian 9)

No	LCD ERROR MESSAGE	Cause	Solution
81	Remove Ribbon (PC Error Message No. 139)	The print Ribbon is not installed properly or has been damaged	Verify the correct Ribbon is installed in the Ribbon Cartridge. Remove it and replace it with the correct Ribbon
82	Remove Lam Mtl (PC Error Message No. 210)	Single Sided Lam job specified but the material is loaded in both Modules	Remove either Lamination Cartridge
83	Remove Lam1 Mtl (PC Error Message No. 204)	Single sided lamination on the back side is specified but material is loaded in the Lam 1 Module	Remove Cartridge 1.
84	Remove Lam2 Mtl (PC Error Message No. 205)	Single sided lamination on the front side is specified but material is loaded in the Lam 2 Module.	Remove Cartridge 2.
85	Ribbon Break/Jam (PC Error Message No. 99, 108, and 109)	The Ribbon is not able to find the next panel correctly. Check for jams/breaks	If jammed, clear the jam. If broken, repair by taping the Ribbon back on to the take-up core. Press Resume to continue or Cancel to abort
86	Ribbon Low (PC Error Message No. 92)	The print Ribbon will soon run out	If printing a large number of cards, replace the Ribbon now or monitor the Printer until the Ribbon is gone and install a new Ribbon.
87	Ribbon Miscue (PC Error Message No. 97)	The Ribbon is not able to find the next panel correctly. Check for jams/breaks	If jammed, clear the jam. If broken repair by taping the Ribbon back on to the take-up core. Press Resume to continue or Cancel to abort
88	Ribbon Out (PC Error Message No. 91, 100 and 101)	The print Ribbon has run out.	Install a new Ribbon and press Resume to continue
89	Ribbon Tension (PC Error Message No. 98)	The Ribbon tensions may be out of range	Check and adjust the setting through the TOOLBOX under the Advanced Settings tab. If this problem persists, call for technical assistance. Press Resume to continue or cancel to abort
90	Ribbon: Wrong Material (PC Error Message No. 93, 122, and 172)	The print Ribbon is not installed properly or has been damaged	Verify the correct Ribbon is installed in the Ribbon Cartridge